CITCO XL-2000 diamond dressing tools
"No turning, no resetting, no maintenance"
The CITCO XL 2000 dressing system offers a long lasting, no maintenance, high productivity tool which covers a wide range of dressing applications, from small I.D. to large centerless and cylindrical wheels.
Each tool is precisely matched to the individual dressing requirement. Diamonds are carefully sorted, selected and handset according to wheel size and type of abrasive. All “H” type CITCO XL 2000 dressers are handset with a specific diamond pattern to provide maximum consistency. “G” type dressers have random diamond dispersion for applications requiring less precision.
CITCO XL 2000 ADVANTAGES
— NO MAINTENANCE
Tool can be completely consumed - no turning or resetting required
— COST EFFECTIVE
Improved dresser life - more dresses per tool and more pieces ground between dresses
— REDUCED TOOL INVENTORY
Can replace single points, grit dressers, clusters and shaped dressers
— APPLICATION VERSATILITY
Use for both contour and straight dressing applications
— CONSISTENT DRESSING
Special diamond pattern keeps tool width and contact area the same throughout tool life for uniform wheel conditioning
— EXTENSIVE AVAILABILITY
Offered with standard 7/16 shank or bolt on adapter. Other shank sizes available by quotation
— Always apply full flood coolant directly on diamond before making any contact with the abrasive grinding wheel
— Mount with the blade parallel to the abrasive wheel’s centerline, tangent to the OD, and at right angle to it’s radius. (See Exhibit 1)
— Mount with a minimum overhang from the dresser post
— For contour dressing, mount so that the aligned diamond surface (L or R) is the leading edge of the feed direction
— Inclination of up to 30 degrees is allowable for contour dressing. (See Exhibit 2)
— Ideal dressing depth: .0005-.001”
— Initial feed rate: 24 IPM
|#1||S||Tool style: |
|S = shank |
H = hold
|#2||H||Tool type: |
|H = handset |
|2 = medium |
4 = hard
|#4||B||Blade width: |
A = 3/8"
|#5||4||Diamond size: |
|12 = elongated |
10 = extra fine
8 = fine
6 = medium
4 = coarse
|#6||C||Blade alignment: |
|C = center |
R = right
L = left
T = twin
|#7||15||Blade offset: |
|00 = zero |
10 = 10 degrees
15 = 15 degrees
Any dresser not covered by this numbering system should be covered by a print.
⇒ For recruitment-related matters (application, etc.), please do not use this form. Make your requests on this page.
In order to address your request, we need to collect the information listed in the form below
Information on data processing
As a data processor, FIVES implements personal data processing when managing your contact request. The data collected are required for this processing and are retained, unless you object, for a period of 6 months from the last contact between you and FIVES. If the information is incomplete, FIVES will not be able to respond to your contact.
The data collected are exclusively for the use of FIVES departments.
Pursuant to current legislation, you have the right to request access to data concerning you, their correction, deletion and portability, as well as a right of limitation over processing of your data.
These rights can be exercised by email to DPO@fivesgroup.com or by post to the Data Protection Officer at the following address: FIVES, 3 Rue Drouot, 75009 Paris, accompanied by a copy of an identity document.
In case of a dispute involving processing of your personal data, you have the right to make a complaint to the French Data Protection Agency (CNIL).
To find out more about our personal data protection policy click here